The flange is an important component of modern toilets. It is used to channel water to the flush. The device must be regularly maintained to ensure good hygiene in your toilet. However, there are times when the wood around the toilet will not flush when you repair the flange. In this case, the following solutions will be useful to you.
Use black soap to clean wood
This product adapts well to all types of wood thanks to its low acid content. Whether you have varnished wood or waxed wood, you can effectively clean it with black soap without impacting its shine. To apply the product to your wood, you must first mix it with an equivalent amount of hot water.
Put the solution on the part you want to clean. Use a cotton cloth to polish the surface of the material. Then you can use a soft-bristled brush to remove the encrusted dirt. Finally, use a damp but clean cloth to rinse the surface.
Apply turpentine against stubborn dirt
This product is specially manufactured to clean, protect and polish wood materials. Turpentine is also very effective in removing all kinds of dirt. The product thus makes it possible to keep the woods always shiny.
Just put a microfiber cloth in the solution and then repeatedly rub the dirty areas. In doing so, you will also be able to remove any wax residue. In addition, some dirt may be more resistant to your cleaning.
You can mix the ammonia with the turpentine solution for better cleaning. Put on a glove and dip a cloth in the liquid to apply it to the wood. Pay more attention to the stains and finally wipe them off with a cloth dipped in lukewarm water.
Use white vinegar to scour the wood
White vinegar can be used to remove any dirt that could dull the clarity of the wood in your toilet. This liquid can allow you to remove even superficial stains and also those installed deep in the wood.
When your wood is varnished, this solution allows you to instantly dissolve the grime to restore its aesthetic appeal. At the end of your cleaning, you must carefully rinse the white vinegar so that its acidity does not affect the varnish of the wood.
Apply steam to remove streaks
The antlers around your toilet can be subject to accidental knocks when handling them. You can hide or delete these traces from your device. It will suffice to spray the affected surface. The trace will be swollen to allow you to erase the sagging area.
To achieve this, you need to lay out a soaked cloth or sheets of absorbent paper on the sagging surface. Put a repair iron thermostat on the linen fabric ironing option and apply it to damp sheets or fabrics. Finally, wax the wood or use varnish to restore its clarity.
Basically, when the antlers around your toilet aren’t flushing while cleaning, you can apply black soap to it. Also, useful solutions are turpentine, white vinegar, and steam.